TP-Link TL-WR802N User Manual page 111

Chapter 5
•
•
Dynamic IPv6
•
•
•
•
•
•
•
Note:
If you get Address not found error when you access a Web site, it is likely that your DNS servers are set up
improperly. You should contact your ISP to get DNS server addresses.
Downloaded from ManualsNet.com
PPPoEv6 - Connections which use PPPoEv6 that requires a username and
password.
Tunnel 6to4 - Connections which use 6to4 address assignment.
IPv6 Address - The IPv6 address assigned by your ISP dynamically.
Prefix Length - The length of IPv6 address prefix.
IPv6 Gateway - Enter the default gateway provided by your ISP.
Addressing Type - There are two types of assignation for IPv6 address:
SLAAC (Stateless address auto-configuration) and DHCPv6 (Dynamic Host
Configuration Protocol for IPv6) Server.
MTU(Bytes) - The normal MTU (Maximum Transmission Unit) value for most
Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the
MTU. But this is rarely required, and should not be done unless you are sure it is
necessary for your ISP connection.
Enable MLD Proxy - Enable the Multicast Listener Discovery (MLD) Proxy
function if you need.
Set IPv6 DNS Server manually
addresses, select Set IPv6 DNS Server manually
and Secondary IPv6 DNS Server
servers will be assigned from ISP dynamically.
search engine
Configure the Router in WISP Mode (Hotspot Mode)
- If your ISP gives you one or two DNS IPv6
and enter the
into the correct fields. Otherwise, the DNS
IPv6 DNS Server
107