Faq - TP-Link TL-WR802N User Manual

FAQ

Q1. What should I do if I cannot access the internet?
• If using a cable modem, unplug the Ethernet cable and reboot the modem. Wait until
its Online LED is on and stable, then reconnect the Ethernet cable to the modem.
• If you're in a hotel room or on a trade show, the internet may be limited and requires
that you authenticate for the service or purchase the internet access.
• If your internet access is still not available, contact TP-Link Technical Support.
Q2. How do I restore the router to its factory default settings?
With the router powered on, press and hold the
then release the button.
Note: You'll need to reconfigure the router to surf the internet once the router is reset
Q3. What should I do if I forget my wireless password?
• If you have not changed the default wireless password, it can be found on the Wi-Fi
Info Card or on the label of the router.
• Otherwise, connect a computer to the router via an Ethernet cable. Log in to the Web
Management page, and go to
wireless password.
Q4. What should I do if I forget my login password of the web management
page?
The default username and password of the web management page are
lowercase). If you have altered the password:
1. Reset the router to factory default settings: With the router powered on, press and
hold the
2. Visit http://tplinkwifi.net, enter
to login.
Note: You'll need to reconfigure the router to surf the internet once the router is reset, and please mark down your new
password for future use.
Q5. What do I need to do if I want to use NetMeeting?
If you start NetMeeting as a sponsor, you don't need to do anything with the router. If
you start as a response, please follow the steps below to configure the router:
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Enable DMZ: Go to
DMZ Host IP Address
Downloaded from ManualsNet.com
Reset button until the LED blinks and then release the button.
Forwarding
field, and then Click Save.
search engine
Reset button until the LED blinks and
Wireless > Wireless Security
admin (in lowercase) as both username and password
> DMZ. Select Enable and enter your IP address in the
to retrieve or reset your
admin (in
175