TP-Link TL-WR802N User Manual page 120

Chapter 5
Note:
The new username and password must not exceed 15 characters and not include any spacing.
3. Click Save.
5. 16. 8. Local Management
This feature allows you to block computers on the LAN from accessing the router by
using the MAC/IP-based authentication.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
• Allow all LAN conencted devices to manage the router locally
1. Keep the
manage the router.
2. If you want to access the router via both HTTPS and HTTP, please tick the
checkbox in
3. Keep the local management port as default if you don't know which port to use.
4. Click Save.
Note:
If the web management port conflicts with the one used for
after the setting is saved.
• Allow a specific device to manage the router locally
1. Enter the IP or MAC address of the host that you want to manage the router in the
Available Host (IP/MAC)
(X is any hexadecimal digit).
2. If you want to access the router via both HTTPS and HTTP, please tick the
in HTTPS Service
3. Keep the Port as default if you don't know which port to use.
4. Click Save.
Note:
If your PC is blocked but you want to access the router again, press and hold the
factory defaults.
• Certificate
Downloaded from ManualsNet.com
System Tools > Administrator, and focus on the
Available Host (IP/MAC)
HTTPS Service column. Otherwise, keep it disbled.
entry. The format of the MAC address is XX:XX:XX:XX:XX:XX
column. Otherwise, keep it disbled.
search engine
Configure the Router in WISP Mode (Hotspot Mode)
Service Configuration
empty, which means you don't specify any host to
Virtual Server entry, the entry will be automatically disabled
section.
Enable
Enable
Reset button to reset the router to the
box
116