Removing A Gpu Card From A Riser Module - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

9.9.2

Removing a GPU card from a riser module

Upgrade and Repair Unit
(URU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove all riser modules, see
▶
"Removing an expansion card from a riser module" on page
▶ If necessary, remove the cables from the expansion cards.
▶
"Removing the air duct" on page
▶ Disconnect the GPU power cable from the system board connector.
Removing the GPU card from a riser module (example NVDIA Tesla A100)
GPU A40/A6000 have the same removement procedure.
RX2540 M6
Expansion cards and backup units
52.
"Removing a riser module" on page
78.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
87.
53.
56.
52.
70.
284.
307