Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 196

Hard disk drive (HDD) / solid state disk (SSD)
The EDSFF SSD module is controlled by an onboard controller. For
more information, see the "Intel Virtual RAID on CPU (Intel VROC) User
Guide".
The VMD function has to be enabled in the BIOS.
If the VMD function is disabled in the BIOS, the EDSFF SSD module is
not supported.
CAUTION
All HDD/SSD modules (drives) must be uniquely identified so that they
can be reinstalled in their original bays later. If this is not done, existing
data can be lost.
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶ Identify the physical location of the EDSFF SSD module, see
configurations" on page
▶ Prepare the removing of the EDSFF SSD module.
▶ Depending on your configuration and OS:
page 52.
Removing the defective EDSFF SSD module
▶ Remove the EDSFF SSD module, see
on page 194.
▶ If applicable, remove the EDSFF SSD from the installation frame, see
"Handling HDDs or SSDs without installation frame" on page
Installing the new EDSFF SSD module
▶ If applicable, install the EDSFF SSD in the installation frame, see
HDDs or SSDs without installation frame" on page
▶ Install the EDSFF SSD module, see
page 192.
196
188.
"Removing an EDSFF SSD module"
"Installing an EDSFF SSD module" on
Upgrade and Maintenance Manual
49.
"Shutting down the server" on
136.
52.
"Overview of
136.
"Handling
RX2540 M6