Handling Memory Dummy Modules - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶
"Resuming BitLocker functionality" on page
After replacing memory modules, the Memory Status of them are reset
to Enabled automatically and CSS LED is off.
If CSS LED is blinking after they are replaced, check the Memory
Status in the Configuration menu of the BIOS.
10.6

Handling memory dummy modules

It is required to install dummy modules in free memory slots. There are
different dummy modules available. The variants can be mixed.
Removing a memory dummy module
▶ Eject the desired dummy module by pressing out the securing clips at each
end of the memory slot.
▶ Remove the ejected dummy module.
Installing a memory dummy module
▶ Press the securing clips on both sides of the memory slot concerned
outward.
RX2540 M6
79.
60.
65.
69.
Upgrade and Maintenance Manual
69.
105.
Main memory
343