Replacing A 24X 2.5-Inch Hdd Backplane And A Switch Board - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
▶ Insert all dummy modules, see
module" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
7.5.9 Replacing a 24x 2.5-inch HDD backplane and a
switch board
The 24x 2.5-inch HDD backplane and the switch board are combined
into one spare part.
Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all PCIe SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
The PCIe SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all PCIe SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
184
"Installing a 2.5-inch HDD/SSD dummy
170.
69.
Upgrade and Maintenance Manual
65.
Hardware: 15 minutes
49.
52.
53.
56.
169.
69.
52.
165.
RX2540 M6