Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 266

Expansion cards and backup units
Removing the defective expansion card
▶ Remove the expansion card, see
page 263.
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
Installing the new expansion card
▶ If applicable, install the slot bracket, see
page 237.
▶ Install the expansion card, see
Concluding steps
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶
"Enabling replaced components in the BIOS" on page
▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 104.
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
266
"Removing the expansion card" on
"Removing slot brackets" on page
"Installing the expansion card" on page
60.
65.
69.
265.
Upgrade and Maintenance Manual
"Installing slot brackets" on
69.
100.
95.
105.
"Note on network settings
239.
256.
107.
RX2540 M6