Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 295

▶
Figure 182: Locking the GPU card
▶ Ensure that the GPU riser latch locks completely in the riser card (see
circle).
▶ Connect the GPU power cable to the system board connector "PWR 9"
(riser module 2) or "PWR 10" (riser module 1).
▶ Install the cross bar, see
▶ Install the air duct, see
▶ Install the corresponding riser module, see
page 72.
RX2540 M6
Expansion cards and backup units
"Installing the cross bar" on page
"Installing the air duct" on page
Upgrade and Maintenance Manual
81.
79.
"Installing a riser module" on
295