Starter Decompressor - Honda XL350R 1984 Shop Manual

MAINTENANCE
Check the clearance of all four valves by inserting
a feeler gauge between the rocker arm and sub
rocker arm.
NOTE
When checking the clearance, slide the feeler
gauge in the arrow d irection as shown.
VALVE CLEARANCES:
INTAKE : 0.05 mm (0.002 in)
EXHAUST: 0.08 mm (0.003 inl
Adjust by loosening the lock nut and turning the
adjusting screw until there is a slight drag on the
feeler gauge.
Hold the adjusting screw and tighten the lock nut.
TOROUE : 15-18 N'm (1.5-18 kg.m, 1'-13 ft-Ibl
Recheck the valve clearance.
Adjust starter decompressor valve lifter lever free
play .
Install parts in the reverse order of
di~ssembly.
STARTER DECDMPRESSOR
NOTE
Always adjust the decompressor linkage after
adjusting the va lve clearance.
Remove the crankshaft and timing mark hole caps.
Rotate the flywheel counterclockwise to align the
" T" mark with the index mark . Make sure the pis-
ton is at TDC (Top Dead Center) on the compres-
sion stroke.
3-8
FEELER GAUGE
VALVE ADJUST ING WRENCH
07708-0030400 or 89201-200- 000
10 x 12 mm WRENCH
07708- 0030200 or
07908-MB001oo
LOCK NUT
"T" MARK