Honda XL350R 1984 Shop Manual page 87

Apply engine oil to the camshaft bearings and install
them
OntO
the camshaft; the sealed bearing goes on
the sprocket side with the seal facing out.
Install the tensioner lifter into the cylinder head .
Apply engine oil to a new O'ring and install it in the
groove of the cam chain tensioner shaft through the
tensioner and into the cylinder head.
Hold the tensioner's lever straight down. Place the
tensioner holder tool's pin into the hole in the ten-
sioner which will be fac ing up .
Slowly release the tensioner lever unti l the tool rests
against the cylinder head casting.
NOTE
Leave the tool in place until the camshaft,
sprocket and chain are installed.
Place the cam sprocket inside the cam chain with
its dished face facing the right side.
Install camshaft through the sprocket and cam
chain.
CYLINDER HEAD / VALVE
LEFT BEAR I NG
RIGHT BEAR I NG
~
SEAL FACES OUT
CAM CHA I N TENSION ER HOLDER
SEALED BEAR ING
CAM SPROCKET
6-19