Honda XL350R 1984 Shop Manual page 89

Turn the tensionet shaft, aligning it with the cylin-
der head edge as shown.
CYLINDER HEAD COVER
ASSEMBLY
Install the rock er arms, sub rocker arms, rocker arm
shafts, sub rocker arm shafts, thrust washer and wave
washers.
Apply liquid sealant to the t hreads of the rocker
arm and sub rocker arm shafts.
T ighten the rocker arm and sub rocker arm shafts.
TORQUE :
ROCKER ARM SHAFT:
25-30 N'm (2.S-3.0 kg-m, 18-22 ft-Ibl
SUB ROCKER ARM SHAFT:
IN : 25-30 N·m
12.5- 3 ,0 kg -m, 18- 22 ft-Ib)
EX : 20- 25 N ·m
(2.0-2.5 kg-m, 14-18 ft·lb)
Apply clean engine oil to the rocker arms and shafts.
CYLINDER HEAD COVER
INSTALLATION
Make sure the piston is at T.D.C. (Top Dead Center)
on the compression stroke.
Install the dowel pins and a new gasket. Pour clean
engine oit into the oil pockets in the head so that
the cam lobes are comp letely submerged .
CYLINDER HEADIVALVES
TENSIONER SHAFT
W\""~
ROCKER ARM
4"OOWE L PIN
GASKET
ROCKER ARM
SHAFTS
-
ON~·i
(
I
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -_ _ _ 0
6-21