Honda XL350R 1984 Shop Manual page 191

Carefully drive the needle bearings and thrust bush-
ings into the swing arm wit h the special tool below
the edge of the hole.
NOTE
I nstall the bearings w ith the marks fac ing out.
Lubricate the bearings wi th grease after installation.
Apply grease to the p ivot collar and install the pivot
collar in the swing arm.
ASSEMB LY
REAR WHEEL/BRAKE /SUSPENSION
DRIVER 07749-0010000
u-_-
r
ATTACHMENT, 32 x 35 07746-0010 100 OR 07946-37 10300
AND PI LOT, 20 mm 07746-0040500
DUST SEALS FOOT PEGS
FOOT GUARD
Install the foot guard, chain guide, foot peg and
I
chain guide slider.
\
Apply grease to the lip of the dust seal, and install
the dust seals.
INSTALLATION
Install the swing arm and torque the pivot bolt.
TORQUE : 80- 100 N·m
(8.0-10,0
kg-m.
58- 72
ft -Ibl
Install the shock arm onto the swing arm.
Tighten the shock arm pivot bolt .
TORQUE : 90- 120N·m
(9.0- 12.0 kitm. 65- 87 ft-Ibl
Install the chain cover.
Install the rear brake linkage.
T ighten the brake pedal pivot bolt .
TORQUE : 35-45 N·m
(3.5-4.5
kg-m.
25-33
f1-lbl
•
CHAIN GUIDE SLIDER
REAR RAKE
LINKAGE
CHAIN GUIDE
13-17