Honda XL350R 1984 Shop Manual page 51

THROTILE VA L V E DISASSEMBLY
NOTE
The following procedures are based on the
primary carburetor. Secondary carburetor as-
sembly/disassembly is the same unless other-
wise noted.
Remove the carburetor lOp cover screws, top cover,
and gasket .
Remove the throttle valve mounting screw.
Remove the throttle link mount nut.
Remove the throttle link, then remove the throttle
valve and thrust washer.
NOTE
On secondary carburetor: Remove the throt-
tle l ink mounting screw, then remove the
throttle li nk .
Re move the screws, link arm, joint and set plate .
Remove the jet needle from the throttle valve.
NOTE
• Do not disassemble the throttle link more
than necessary .
• Mark the primary and secondary jet
needles to ensure correct reassembly.
Inspect the tip of the jet needle for wear or damage.
Inspect the throttle valve for wear or damage.
FUEL SYSTEM
CARBURETOR TOP COVER
SCREWS
MOUNT I NG SCREWS
PRIMARY
MOUNTING NUT
THROTT L E LINK
SCREW
THROTT L E VALVE
SET PLATE JO I NT
1(~)
JET NEEDLE SCRE'NS LINK ARM
4-7