Furuno GP-3500 Operator's Manual page 77

10. Rotate the [ENTER] knob to select WAYPOINT NAME.
11. Operate the trackball to enter the waypoint name. (Max. six characters)
a) Operate the trackball to select the first character. You can enter numeric
data with the numeric keys.
b) Press the [ENTER] knob.
Note: If you enter a wrong character, re-enter the correct character after
placing the moving the character cursor on the wrong character. To
move the character cursor, select ◄ or ► and then press the [ENTER]
knob.
To erase all character press the [CLEAR] key.
c) Repeat steps a) and b) to complete the waypoint name.
12. Select "END" by operating the trackball, and then press the [ENTER] knob.
13. Rotate the [ENTER] knob to select MARK COLOR.
14. Roll the trackball in left-right direction to select a color.
You can select color by pressing the appropriate numeric key.
Note: Waypoint mark color and shape cannot be selected when PRXMTY
RADIUS is other than 0.00.
15. Rotate the [ENTER] knob to select MARK SHAPE.
16. Roll the trackball in left-right direction to select a shape.
17. Rotate the [ENTER] knob to select MARK DISPLAY.
18. Press appropriate numeric key to select "1. ON" or "2. OFF"
ON: The waypoint is show waypoints on the plotter (or pilot) display.
OFF: The waypoint is not shown on the plotter (or pilot) display.
Also, waypoint mark is gray in the WAYPOINT LIST.
19. Rotate the [ENTER] knob to select PRXMTY RADIUS.
20. Use the numeric keys to enter the proximity radius.
This is the alarm range that will be used for this waypoint when the proximity
alarm is active. When the proximity radius is other than 0.00, the waypoint mark
becomes automatically. For how to set the proximity alarm, see paragraph
8.4.
21. Rotate the [ENTER] knob to select COMMENT.
22. Operate the trackball to enter the comment (max. 13 characters).
23. Select "END," and then press the [ENTER] knob to finish.
24. Press the [ENTER] knob again.
The waypoint edit window disappears, and the waypoint is registered in the
WAYPOINTS LIST.
25. To enter another waypoint, repeat steps 3 through 24.
26. Press the [MENU] key several times to close the menu.
5. WAYPOINT
5-5