Mercedes-Benz S-Class 2020 Owner's Manual page 269

266 Driving and parking
ESP ® is deactivated.
R
A loss of tyre pressure or a defective tyre is
R
detected.
Transport equipment, for example a trailer or
R
bicycle rack, is attached to the trailer hitch
and the electrical connection has been cor‐
rectly established.
Activating/deactivating Active Blind Spot
Assist
Multimedia system:
© Settings Assistance
4 5 5
Avoid collision Active Blind Spot Assist
5 5
Select Active Blind Spot Assist.
#
Select On or Off.
#
Active Lane Keeping Assist
Function of Active Lane Keeping Assist
Active Lane Keeping Assist monitors the area in
front of your vehicle by means of the multifunc‐
tion camera ( page 231) and can warn you
/
before you leave your lane unintentionally. The
system can guide you back into your lane
through a course-correcting steering interven‐
tion and additionally warns you with vibration
pulses in the steering wheel. Active Lane Keep‐
ing Assist is available in the speed range
between 60 km/h and 200 km/h.
The system can intervene in the following situa‐
tions:
Active Lane Keeping Assist detects a lane
R
marking.
One of your front wheels goes over a lane
R
marking.
If you activate the turn signal indicator, a steer‐
ing intervention does not occur on the corre‐
sponding side.
If the system detects an obstacle, such as
another vehicle in the adjacent lane, a steering
intervention occurs regardless of the turn signal
indicator. If you leave the lane without using the
turn signal indicator, but an obstacle is detected
in your lane, a steering intervention does not
occur.
Display 1 will appear in the driver display and a
warning tone will sound in the following situa‐
tions:
A steering intervention by Active Lane Keep‐
R
ing Assist lasts longer than approximately ten
seconds.
The system carries out two or more steering
R
interventions within approximately three
minutes without any steering intervention
from the driver.
In the Active Lane Keeping Assist settings, you
can set the sensitivity of the system and set the
level of support. Additionally, you can set
whether the system should react to discontinu‐