Sony ZRD-1 Installation Manual page 78

Adjustment procedure
1. Perform step 1 to step 5 as described previously taking care of the following points.
. The joint at the both sides of the display unit should not be conspicuous in the Z direction.
. The difference level in the center should be as small as possible.
t
It is no problem that the joint is visible in the center at this point in time.
2. Temporarily secure the adjustment screws to the position as shown in the figure.
Adjustment screw
Joint position to be fine adjusted
3. Insert the hexagon socket bolt into the circular hole on the adjustment plate. Insert the adjustment
plate into the groove of the adjustment screw in the direction of the arrow A. Secure the hexagon
socket bolt.
n
. Insert a tip of the adjustment plate into the groove of the adjustment screw securely.
. Tighten the hexagon socket bolt lightly by hand first, and then tighten it by the ball-pointed hexa-
gon wrench. (Tightening torque: 3.0 ?0.3 N.m)
Adjustment screw
A
Hexagon
socket bolt
Adjustment plate
2-44 (E)
Tighten the screw by hand until the distance from
the frame to the screw flange is 4 mm.
Insert a tip of the
adjustment plate into
the groove at the base
of the adjustment screw. Use the ball-pointed
hexagon wrench.
Ball-pointed hexagon
wrench enables to turn
even tilted.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200