Sony ZRD-1 Installation Manual page 63

4. Attach the unit alignment tool to the display unit.
(1) Attach the unit alignment tool and start it. (Refer to steps 4-(1) to 4-(5) in Section 2-4-3.)
(2) Select the previously set display unit on the monitor. ([Layout] button, orange → blue)
(3) Select the display unit to be set on the monitor. (orange)
5. Align the display unit in the Z direction.
(1) Switch the monitor screen of the unit alignment tool to the Z direction adjusting screen. ([Z]
button)
(2) Insert the eccentric pins (short) into the four Z adjusting holes. Insert the hexagon wrench into
the eccentric pins (short).
. Insert the eccentric pins (short) vertically all the way to the end.
. If you have difficulty in inserting the eccentric pins (short) into the Z adjusting holes, slightly
rotate the eccentric pins (short) to find the position into which they can be inserted.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Eccentric pin (short)
Hexagon wrench
Eccentric pin (short)
Z adjusting hole
Z adjusting hole
Hexagon wrench
2-29 (E)