Sony ZRD-1 Installation Manual page 107

(2) Click the block to which the address is set.
The following two addresses are displayed in [Unit Address] automatically.
. Display unit layout address (Example: C1-10-6)
. Picture allocation number (Example: 19)
. [Reset] of [All Unit Allocation]: All addresses of the selected display controller are deleted.
. After setting has been completed using the connection pattern, you can manually edit the settings.
When manually editing the settings, click
. When confirming the settings, proceed to step 8.
5. Set the display unit layout address manually.
(1) Click the port number. (Default: port 1)
Set from the empty port of smaller number.
(2) Click the block to which the address is set.
The display unit layout address (example: C1-10-6) is set.
. You can set the address to the empty block.
. When the display unit layout address is set to "6", the setting proceeds to the next port number
automatically. Also, you can click another port number.
. To delete the setting, click the set block again.
. You can delete the setting one by one using the right-click menu. Even if the setting has been made
using the connection pattern, you can also delete the setting one at a time after clicking
.
(Color display): Unit number of selected display controller
C1-10-6
(Gray display): Not selected
C1-10-6
6. Click [Picture Allocation].
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
first, then proceed to step 5.
Port number
.
6-11 (E)