Installation; Preparation; Required Equipment/Tools - Sony ZRD-1 Installation Manual

2-4. Installation

2-4-1. Preparation

1. Assemble all bases and install them. (Refer to Section 1-3-1.)
Fix the bases to the floor with the anchors.
2. Assemble all back frames. (Refer to Section 1-3-2.)
Fix the back frames to the floor, wall and ceiling with the anchors.
3. Set the number of display units and layout of the whole array in advance using the unit alignment
tool.
For details on the setting procedure, refer to the document supplied with the unit alignment tool.

2-4-2. Required Equipment/Tools

For details on each tool, refer to "1-3. Required Equipment/Tools".
Prepare the general tools such as screwdriver and hexagon wrench.
Equipment/tools No. of pcs
_
Base
_
Back frame
_
Mounting parts
_
Unit alignment tool
. Camera block
1
. Monitor block
1
. Adaptor
2
. Digital level
1
. AC cable
1
. AC cable
1
. Eccentric pin (long)
(*)
4
. Eccentric pin (short) (*)
4
. Shaft lock bar (*)
1
. Hexagon wrench
4
. X positioning tool
2
_
Hexagon wrench bit
(subtense:4 mm)
_
Torque driver (3.0 N.m)
(*) If you break or lose a tool, you can purchase the tool only what you require.
Name
Eccentric pin (long)
Eccentric pin (short)
Shaft lock bar
2-8 (E)
Uses
For connecting between display unit and back
frame
Measurement block
Indication block
The support parts of the camera block and
the monitor block
For checking the inclination between display
unit and back frame
For battery of the camera block
For indication monitor
For adjustment in the X direction or in the Y
direction
For adjustment in the Z direction or in the X
direction
For locking/unlocking a shaft
For the eccentric pin driver
For positioning X direction (It is used when
you install the first display unit in the system.)
For tightening the mounting screw of a joint
coma
For tightening the mounting screw of a joint
coma
Part No. No. of pcs
4-733-542-01 1
4-733-541-01 1
4-733-543-01 1
Remarks
Joint cam plate should be attached.
For the base, including the required
equipment/tools, refer to Section 1-3-1.
Refer to Section 1-3-2.
Refer to Section 1-3-2.
For obtaining these tools, contact your
local Sony Sales Office/Service Center.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200