Display Controller - Sony ZRD-1 Installation Manual

Operation
. Do not block the vent when operating the display unit.
. When cleaning the surface of display unit, use the anti-static soft cloth which causes less fiber shedding.
(Recommended cloth: savina MX wiping cloth made by KB SEIREN, LTD.)
When the surface is very dirty, use ethyl alcohol (nearly 100%). Do not use other solvent other than the
ethyl alcohol. For the contamination of joint portion, use the anti-static air blaster that is commercially
available.
. Do not moisten the surface of a display unit.
. The display unit has sharp edges. To prevent an injury from occurring, take care that the customer does
not directly touch an array.
Storage (when moving the display unit temporarily)
. Be sure to dry it before packing the display unit.
. Store display unit in a dry and well-ventilated place.
. When storing the display unit in a flight case, remove the dust on the surface of the display unit and
attach a protection cover and protection plate.

1-4-2. Display Controller

Common items
. Do not use the display controller in a place subject to vibration or shock.
. Do not use it near a dusty place and poisonous gas.
. Do not perform installation, operation, and storage in the operating environment where dew condensa-
tion may occur in the display controller.
. Do not place the display controller in a place where water may be splashed. If the display controller is
immersed in water, consult the service representative without turning on the power.
. If any abnormality or problem occurs or a foreign substance is put in the display controller, pull out the
power plug and consult the service representative without using the display controller.
Installation
. The category 7 cable to transmit the video signal from the display controller to the display unit is not
supplied. Use the cable with the connectors that have the specified materials, size, and shape.
Also, the cable to connect the display controller and PC (Ethernet cable (category 5), or USB cable) is
not supplied. Prepare the cable that meets the specifications.
. Connect the safety ground to the display controller. Otherwise, it may cause electrical shock.
Connect the ground wire also to
during the operation check and repair work.
1-20 (E)
(ground) terminal. Be sure to connect the safety ground even
(Ground) terminal
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200