Sony ZRD-1 Installation Manual page 120

3. In [Input Select], select the input channel.
All display controllers are set to the same settings.
As for the video signal that can be displayed, refer to "1-1-3. Signal Format".
As for the settings required for each video signal, refer to "A-1. Table of Settings for Video Signal".
[HDMI1] (ZRCT-200 only):
Displays the picture using the HDMI1 connector.
[HDMI2] (ZRCT-200 only):
Displays the picture using the HDMI2 connector.
[DVI] (ZRCT-100 only):
Displays a maximum of 4K 60p picture using the DVI connectors. (Four DVI connectors are used.)
The port number and picture allocation number corresponding to each connector are as follows.
The picture display position is determined according to the picture allocation settings. (Refer to
"6-3-2. Display Unit Layout Setting".)
Connector
DVI 1 connector
DVI 2 connector
DVI 3 connector
DVI 4 connector
Example)
DVI 1 connector
DVI 2 connector
6-24 (E)
Available port number
Port 1 to Port 6
Port 1 to Port 6
Port 7 to Port 12
Port 7 to Port 12
DVI 3 connector
DVI 4 connector
Available picture allocation number
1 to 36
1 to 36
37 to 72
37 to 72
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200