Sony ZRD-1 Installation Manual page 144

System for 3D Dual Input mode
In the case that the DisplayPort connectors are used to input the 3D video, input the L signal (60 Hz) to
the DisplayPort 1 connector, and input the R signal (60 Hz) to the DisplayPort 2 connector.
In the case that the DVI connectors (ZRCT-100 only) are used to input the 3D video, input the L signal (60
Hz) to the DVI 1 connector, and input the R signal (60 Hz) to the DVI 3 connector.
From the display controller, the 3D video signal (120 Hz) in which the L signal and the R signal are
arranged alternately is output.
From the 3D SYNC OUT connector, the 3D sync signal generated in the display controller is output in
accordance with the picture output's timing, and then the 3D sync signal controls 3D glasses via an emit-
ter.
3D video signal
(120 Hz)
( ) : DVI is supported only by ZRCT-100.
Notice on equipment and connection
The following emitter and 3D glasses are recommended.
. Emitter:
AD025-RF-X1
. 3D glasses: TDG-BT500A
About emitter
If you use the emitter except for the recommendation, be sure to use the emitter with a cable length of 3 m
or less.
About cable
For the 3D SYNC IN connector, connect a cable with length of 3 m or less.
6-48 (E)
DisplayPort 1
(60 Hz)
or
DVI 1 ( )
L1 L60
(60 Hz)
DisplayPort 2
or
DVI 3 ( )
R1 R60
3D sync signal (120 Hz)
3D SYNC OUT
3D video signal (120 Hz)
L1 R1 L60
Emitter
R60
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200