The Restore Controller Data screen is displayed. (The screen varies depending on the Display Control
Software version.)
5. Click [System Migration] in [Restore Mode Selection].
6. Place the check marks for all display controllers.
7. Double-click an IP address or a COM port on [IP Address] in [Controller Selection].
8. Change the IP address or the COM port.
9. Click [Connect].
Check the following items.
. The serial number is displayed on [Serial No.].
. [OK] is displayed on [Data Status].
10. Click [OK] or [Apply].
[OK]:
The display returns to the Main screen when the migration is completed.
[Apply]: There is no screen transition when the migration is completed.
The following dialog is displayed.
6-44 (E)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200