Sony ZRD-1 Installation Manual page 135

3. Select a target display controller, and then click [Detailed Input Settings].
The Detailed Input Settings screen is displayed.
Screen example (The screen varies depending on the Display Control Software version.)
Version earlier than 1.20.0
Version 1.22.0 or later
4. Click the tab of the video signal that you want to change the display starting position.
t
The settings in the [DVI] tab work on ZRCT-100 only. The settings in the [HDMI1] tab and [HDMI2]
tab work on ZRCT-200 only.
5. Set the position in the horizontal direction by [H Position], and in vertical direction by [V Position].
When the settings are changed, they are reflected immediately.
Change the setting using the sliding lever and
changes.
Item Shift direction
[H Position] When you move the sliding lever to
the right, the picture shifts to the right.
[V Position] When you move the sliding lever to
the right, the picture shifts to the lower.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Tab of the video signal
Tab of the video signal
. When you move the sliding lever, the value also
Default (Upper left)
0
0
Version 1.20.0 through earlier than 1.22.0
Range
_3840 to +3840
The setting value varies in 4 increments.
_2160 to +2160
Tab of the video signal
6-39 (E)