Sony ZRD-1 Installation Manual page 113

2 [System Power]:
3 [System Status]:
[Operation Normal]:
[Controller Error]:
[Controller Warning]:
[Controller Connection Failure]:
[Controller Authentication Failure] (Except for S/N 2000001 to 2000100 of ZRCT-100 SY
4 [Controller List]
[Power Status]:
[Error]:
About the display controller information
The display controller information is displayed when you select the controller number, and double-
click the list or right-click on [Controller Info.]. For details, refer to "Display controller information"
described later in this section.
5 [Array Preview]
Displays only the part of the entire array that is displayed in [Array Information] in green block.
6 [Array Information]: Displays the display unit information.
: Power of the display unit is turned on.
C4-8-8
: Power of the display unit is not turned on.
C4-8-8
: There is an abnormality (error) in the display unit.
C4-8-8
: There is an abnormality (warning) in the display unit.
C4-8-8
: Empty unit
About the display unit information
The display unit information is displayed when you double-click in the block or right-click on [Display
Unit Info.]. For details, refer to "Display unit information" described later in this section.
7 [Display Unit Power] (Version 1.22.0 or later): Refer to Section 6-20.
8 [Blank] (Version 1.22.0 or later):
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Refer to Section 6-4.
Displays the status of system and controller.
Normal operation
The device does not operate normally. The display con-
troller and display units enter standby state, and no
picture is displayed. For details on the contents of error,
refer to [Error] in [Controller List].
Even if the device operates, check the contents of warn-
ing. The problem should be resolved as soon as possible.
The fan abnormality, picture sync error, etc. have oc-
curred.
For details on the contents of warning, refer to [Error] in
[Controller List].
Displays the contents of warning when the failure is
detected in the connection between the system and the
display controllers.
model):
Displays the contents of warning when the authentication
cannot be executed due to the wrong password.
"_" indicates that the communication with the display
controller cannot be made.
"None" indicates that there is no error and warning.
Refer to Section 6-21.
6-17 (E)