Sony ZRD-1 Installation Manual page 122

[Input Signal Status]
Displays the video input signal information for each input port. The resolution and frame rate are
displayed. The display is updated approximately every 15 seconds.
[Unsupported Signal]: The signal is unsupported.
[Input Sync Status]
Displays the sync status of video input signal. The display is updated approximately every 15 sec-
onds.
[OK]: The primary controller is synchronized by obtaining the sync signal from the video
signal. The sub controller is linked with the primary controller via the LINK
connector.
[No Sync]: There is no sync signal in the display controller. Or, no sync signal is input. It is
displayed in red characters.
[Out Of Range]: Although the sync signal is input in the display controller, the signal is out of
range. It is displayed in red characters.
[3D Signal Status] (Except for S/N 2000001 to 2000100 of ZRCT-100 SY model)
Displays the mode of the 3D video signal and the error information of the 3D sync signal. The display
is updated approximately every 15 seconds. If an error occurred, the characters of the mode and error
information are displayed in red.
[2D/3D Frame Sequential Mode] (ZRCT-100 except for S/N 2000001 to 2000100 of SY model, or
ZRCT-200 with version earlier than 1.22.00):
[3D Frame Sequential Mode] (ZRCT-200 with version 1.22.00 or later):
[3D Dual Input Mode]:
[Frequency Error]:
[Duty Cycle Error]:
[No Sync]:
[2D] (ZRCT-200 only):
t
You can also change the following settings.
. Changing the Display Starting Position of Picture (Refer to Section 6-14.)
. Displaying the Picture of DisplayPort (Dual) from a Distance (Refer to Section 6-15.)
. Changing the setting for the HDMI video. (Refer to Section 6-19.)
4. Confirm the setting.
[OK]: T he setting value is registered in the display controller. The display returns to the Main
screen.
[Apply]: The setting value is registered in the display controller. There is no screen display transi-
tion.
[Cancel]: The display returns to the Main screen without saving the settings.
6-26 (E)
Refer to Section 6-17.
Refer to Section 6-17.
Refer to Section 6-17.
A frequency of 3D sync signal that is input in the 3D SYNC IN
connector is abnormal. Or, a frequency is out of range.
A duty cycle of 3D sync signal that is input in the 3D SYNC IN
connector is abnormal.
No 3D sync signal is input in the 3D SYNC IN connector.
2D video signal is input in the HDMI connector (version 1.20.00
through 1.21.01). Or, 2D video signal is input (version 1.22.00 or
later).
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200