Sony ZRD-1 Installation Manual page 117

Version 1.22.0 or later
[Sync] block (Except for S/N 2000001 to 2000100 of ZRCT-100 SY model)
. [Sync Signal Selection]
Selects a sync signal.
[Input Sync Signal]:
[External Sync Signal]: The display controller synchronizes with an external sync signal. (Refer to
. [Unit Light Delay]
Adjusts the light delay time of the display unit in accordance with a sync signal (0 to +4000).
The video can be delayed up to 1 frame. You can set the value up to 4000, but the video does not vary
more than the following value.
. 96 Hz: Approximately 3312
. 100 Hz: Approximately 3179
. 120 Hz: Approximately 2649
Change the setting using the sliding lever and
changes.
[Default]: 0
[Fan Mode]
Sets the operation mode of fan in the display units.
[Standard]: Standard operation. The fan runs in optimum speed according to the temperature around
the array (display units).
[Silent]: The fan runs in low-speed for reducing its rotating noise.
Lower the temperature around the array or reduce the light output (or brightness of array)
not so as to occur the temperature error/warning.
[Stop]: The fan stops for silence.
Lower the temperature around the array or reduce the light output (or brightness of array)
not so as to occur the temperature error/warning.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
The display controller synchronizes with an input video signal.
Section 6-18.)
Supporting external sync signals
. HD three-level sync (0.6 V p-p/75 Z/Sync negative)
. SD black-burst/Composite sync (0.286 V p-p/75 Z/Sync negative)
. When you move the sliding lever, the value also
6-21 (E)