Sony ZRD-1 Installation Manual page 111

3. If the Main screen is displayed without backing up in step 2, click [Power ON].
All display controllers and display units after initial settings are powered on. (The screen varies
depending on the Display Control Software version.)
By clicking [Standby]
All connected display controllers and display units enter standby state. The Main screen remains dis-
played as it is.
When you click [Power ON], the power is turned on again.
About [Display Unit Power], [OFF]/[ON]
In the version 1.22.0 or later, you can make only the display units standby state. (Refer to Section 6-20.)
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
6-15 (E)