Bobbin Winder; Adjusting The Winder To A Bobbin Diameter - Dürkopp Adler D869 e-con Service Instructions Manual

12 Bobbin winder

12.1 Adjusting the winder to a bobbin diameter

Fig. 64: Adjusting the winder to a bobbin diameter
(1) - Threaded pin
To adjust the winder to a bobbin diameter:
1. Set the winder lever (2) to the ring that corresponds to the desired
2. To fine-tune the setting, put a completely filled bobbin onto the winder.
3. Press the winder lever (2) up to the thread as far as it will go by turning
78
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before adjusting the winder.
32 mm
28 mm
bobbin diameter. To do so, screw the threaded pin (1) in or out.
the threaded pin (2).
②
①
(2) - Bobbin winder lever
Service Instructions D869 e-con - 00.0 - 09/2023
Bobbin winder