Setting The Winder - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 111

4.3 Setting the winder

Fig. 12: Setting the winder
(1) - Bobbin winder flap
(2) - Screw
Proper setting
The winder should automatically cut off if the bobbin is filled to approx.
0.5 mm below the edge of the winder. The bobbin should be wound
cylindrically.
To set the winder:
1. Small changes to the filling quantity
1. Set the bobbin winder flap (1) using the screw (2).
2. Large changes to the filling quantity
1. Remove the arm cover.
2. Loosen the screw (4).
3. Turn the switch cam (3).
4. Tighten the screw (4).
5. Assemble the arm cover.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
① ②
• To set a smaller filling quantity: Turn in arrow direction A
• To set a larger filling quantity: Turn in arrow direction B
B
③ ④
(3) - Switch cam
(4) - Screw
A
33