Table of Contents
Advertisement
Earth
Fasten the copper strap (supplied) between the
earth terminal on the display unit and the ship's
superstructure.
2.2 Connection of Optional Equipment
Navigator
Use cable type MJ-A6SPF0011/0012 (option) to connect a navigator (GPS, etc.) to the
NMEA connector at the rear of the display unit. For details, see the interconnection dia-
gram at the end of this manual.
Water temperature sensor (T-02MSB, T-02MTB, T-03MSB)
Connect the water temperature sensor to the TEMP connector at the rear of the display
unit.
Note: The navigator and the water temperature sensor use the same type of connector.
Be sure not to confuse them when connecting.
Net Sonde FNZ-18
Use connector type FM14-8P (optional supply) and 5-twisted pair cable type CO-SPEVV-
SB-CO 0.2X5P (optional supply). Attach the connector to the cable as below. Connect the
cable between the CIF port on the display unit of the FNZ-18 and the SONDE connector at
the rear of the display unit. Be sure the shield of the interconnection cable lies in the cable
clamp of the connector (both FNZ-18 and FCV-1500/M). (Analog sonde signal and sonde
temperature are also available. For details see the interconnection diagram at the end of
this manual and the installation manual of the FNZ-18.)
3. Solder cores to connector
pins; clamp shield.
1. Remove sheath
2. Fold back the shield onto
by 15 mm.
Figure 2-5 How to attach FM14-8P connector
CAUTION
Ground the equipment to
prevent electrical shock
and mutual interference.
the cable; cut unused cores.
Vinyl tape
4. Tape shield with vinyl tape.
(Be sure no gap exists
between clamp and tape.)
6
Advertisement
Table of Contents
