Monitor Cli Commands - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
2.9.2.4
filter
Syntax filter
Context monitor
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description Commands in this context configure criteria to monitor IP and MAC filter statistics.
ip
Syntax ip ip-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>filter
monitor>management-access-filter
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command enables IP filter monitoring. The statistical information for the specified IP filter
entry is displayed at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IP filter. The subsequent
statistical information listed for each interval is displayed as a delta to the previous screen
output.
When the keyword rate is specified, the rate per second for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters ip-filter-id — Displays detailed information for the specified filter ID and its filter entries.
entry entry-id — Displays information on the specified filter entry ID for the specified filter
interval seconds — Specifies the interval for each display in seconds.
3HE 17358 AAAB TQZZA

Monitor CLI Commands

Values 1 to 65535
ID only.
Values 1 to 65535
Default 5 seconds
Values 3 to 60
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
CLI Usage
75