Table 71 Output Fields: Ntp - Nokia 7210 Configuration Manual

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

System Management
Table 71
600
Output Fields: NTP (Continued)
Label
Reference ID
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Description (Continued)
When stratum is between 0 and 15 this field shows the IP
address of the remote NTP server or peer with which the remote
is exchanging NTP packets
For reference clocks, this field shows the identification assigned
to the clock, such as, ".GPS."
For an NTP server or peer, if the client has not yet synchronized
to a server/peer, the status cannot be determined and displays
the following codes:
Peer Codes:
ACST — The association belongs to any cast server
AUTH — Server authentication failed. Wait while the association
is restarted.
AUTO — Autokey sequence failed. Wait while the association is
restarted.
BCST — The association belongs to a broadcast server
CRPT — Cryptographic authentication or identification failed.
The details should be in the system log file or the cryptostats
statistics file, if configured. No further messages will be sent to
the server.
DENY — Access denied by remote server. No further messages
will be sent to the server.
DROP — Lost peer in symmetric mode. Wait while the
association is restarted.
RSTR — Access denied due to local policy. No further messages
will be sent to the server.
INIT — The association has not yet synchronized for the first time
MCST — The association belongs to a manycast server
NKEY — No key found. Either the key was never installed or is
not trusted.
RATE — Rate exceeded. The server has temporarily denied
access because the client exceeded the rate threshold.
RMOT — The association from a remote host running ntpdc has
had unauthorized attempted access.
STEP — A step change in system time has occurred, but the
association has not yet re-synchronized.
System Codes:
INIT — The system clock has not yet synchronized for the first
time
STEP — A step change in system time has occurred, but the
system clock has not yet re-synchronized
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents