System Boot Options For 7210 Sas-Mxp, 7210 Sas-S 1/10Ge, 7210 Sas-Sx 1/10Ge, And 7210 Sas-Sx 10/100Ge In Standalone Mode - Nokia 7210 Configuration Manual

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

Boot Options
After the uplinks are connected and the node is powered up, the satellite node sends
out DHCP packets. The host matches the MAC address in the DHCP packet against
the host configuration to identify the satellite and provides the correct BOF to the
satellite node for booting up. The BOF sets the host-type command to satellites and
also provides the location of the TiMOS (SR OS) image and configuration file. The
boot loader fetches the TiMOS image and configuration file and boots up in satellite
mode.
Note: When operating the 7210 SAS platform in satellite mode, Nokia recommends to use
only the auto-init procedure to retrieve the BOF and other boot parameters from the host.
Other procedures, such as the manual configuration of the BOF, are not allowed. See
init Mode
4.1.4.5
Note: See the
7210 SAS-Sx/S 1/10GE operating in standalone-VC mode.
When operating in standalone mode, these 7210 SAS platforms support the
following options to boot the system:
Because multiple storage locations are available for the boot loader (boot.tim) on the
7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE, and 7210 SAS-Sx 10/100GE, these
platforms do not support the golden bootstrap image.
During bootup, the bootrom searches for the boot.tim in the following locations in the
specified order and uses the image obtained from the first location where boot.tim is
found to load the bootstrap image:
130
for more information.
System Boot Options for 7210 SAS-Mxp, 7210 SAS-S 1/
10GE, 7210 SAS-Sx 1/10GE, and 7210 SAS-Sx 10/100GE in
Standalone Mode
Virtual Chassis
• internal flash (cf1:\)
• external SD card slot (cf2:\)
• external USB flash (uf1:\) (not available for 7210 SAS-S 1/10GE)
• network (with auto-init; auto-init is not supported on platforms operating in
standalone-VC mode)
• network (without auto-init)
• cf1:\ (internal USB)
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
chapter for information about boot up and configuration of the
© 2021 Nokia.
Configuration Guide
Auto-
3HE 17358 AAAB TQZZA

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents