Nokia 7210 Configuration Manual page 328

System Management
Example:
Authentication-key
This command configures an authentication key ID, key type, and key used to
authenticate NTP PDUs sent to and received from other network elements
participating in the NTP protocol. For authentication to work, the authentication key
ID, authentication type and authentication key value must match.
Use the following CLI syntax to configure an authentication key ID, key type, and key.
CLI Syntax:
The following example shows the command usage to configure an authentication
key-id, key type, and key.
Example:
The following sample configuration shows NTP disabled with the authentication-
key parameter enabled.
A:sim1>config>system>time>ntp# info
----------------------------------------------
----------------------------------------------
A:sim1>config>system>time>ntp#
Broadcast
The broadcast command is used to transmit broadcast packets on a specific subnet.
Use the following CLI syntax to transmit broadcast packets.
CLI Syntax:
328
config>system>time>ntp#
config>system>time>ntp# authentication-check
config>system>time>ntp# no shutdown
config>system>time>ntp
authentication-key key-id {key key} [hash | hash2]
type
{des|message-digest}
config>system>time>ntp#
config>system>time>ntp# authentication-key 1 key A type
des
config>system>time>ntp# no shutdown
shutdown
authentication-key 1 key "OAwgNUlbzgI" hash2 type des
config>system>time>ntp
broadcast [router router-name]{interface
ip-int-name}[key-id key-id] [version version][ttl
ttl]
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 17358 AAAB TQZZA