Searching For The Bof; Sample Output Of Bof Configuration On Bootup For 7210 Sas Platforms - Nokia 7210 Configuration Manual

Boot Options
4.10.3.1
The BOF should be on the same drive as the bootstrap image file. If the system
cannot load or cannot find the BOF, the system checks whether the boot sequence
was manually interrupted or else continues with the auto-init mode. The system
prompts for a different image and configuration location.
Note: Auto-init is not supported on the 7210 SAS-R6 and 7210 SAS-R12; use the starter
BOF or create a BOF manually to boot the system.
4.10.3.2
This section provides sample output of a BOF configuration boot sequence for the
following 7210 SAS platforms:
4.10.3.2.1
The following is a sample output of a manually interrupted boot sequence on the
7210 SAS-M, 7210 SAS-Mxp, and 7210 SAS-T.
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
You must supply some required Boot Options. At any prompt, you can type:
Press ENTER to begin, or 'flash' to enter firmware update, or the shell password...
Software Location
158

Searching for the BOF

Sample Output of BOF Configuration on Bootup for 7210
SAS Platforms
• Sample Output: BOF Configuration on Bootup for 7210 SAS-M, 7210 SAS-Mxp,
and 7210 SAS-T
• Sample Output: BOF Configuration on Bootup for 7210 SAS-R6 and
7210 SAS-R12
• Sample Output: BOF Configuration on Bootup for 7210 SAS-Sx/S 1/10GE
Sample Output: BOF Configuration on Bootup for 7210 SAS-M,
7210 SAS-Mxp, and 7210 SAS-T
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"reset" - reset the bof and reboot.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA