Nokia 7210 Configuration Manual page 697

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Config File URL:
Step 8. At the prompt, enter the URL location of the configuration file. The following
Boot Interface Management
-------------------------
Existing uplinkA port settings are:
Step 9. At the prompt, enter edit to change the port settings. The following console
Existing uplinkA port for Boot Interface Management is port 1/1/11.
Press ENTER to keep it.
Enter the new uplinkA port number for Boot Interface Management:
Step 10. At the prompt, enter the front-panel port that is connected to the network
Enter uplinkA speed and duplex settings:
Step 11. At the prompt, enter uplink port speed and duplex settings The following
Auto-Negotiation is currently disabled.
Press ENTER to proceed with existing setting or 'auto' to enable auto-negotiation.
auto
Auto-negotiation will be enabled on uplinkA port.
Existing VLAN Id for uplinkA port is VLAN Id 0.
Press ENTER to keep it.
Enter the new VLAN Id for uplinkA port:
3HE 17358 AAAB TQZZA
console output is displayed.
You specified a network location for either the
software or the configuration file. You need to
configure either eth-mgmt or uplinkA or uplinkB ports.
You will be asked to configure the port number, IP(v6) address,
static routes, and VLAN Id in case of uplink ports.
uplinkA-port
1/1/11
no uplinkA-autoneg
uplinkA-duplex
full
uplinkA-speed
10000
uplinkA-address
0
uplinkA-address
0
uplinkA-vlan
0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
output is displayed.
(for example, 1/1/10). The following console output is displayed.
console output is displayed.
You need to configure the VLAN Id for this port
VLAN Id can be between 0 to 4094. To send out
packets with out any VLAN tags, type "null".
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
697

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents