Table 63 Number Of Resources Available For Maximum Ip Subnets - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Table 63
max-ipv6-routes
Syntax [no] max-ipv6-routes number
Context configure>system>resource-profile>router
configure>system>global-res-profile>router
Platforms Supported on all 7210 SAS platforms as described in this document
Description
Note: The configure>system>resource-profile>router context is supported on the
7210 SAS-M, 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone), and
7210 SAS-Sx 10/100GE.
The configure>system>global-res-profile>router context is supported on the
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE (standalone-VC).
This command allocates route entries for /64-bit IPv6 prefix. Entries in the IPv4 forwarding
table are shared among IPv4 and IPv6 routes. Before adding routes for IPv6 destinations,
route entries in the route lookup table must be allocated for IPv6 addresses using this
command. The remainder of the L3 forwarding table is used for IPv4 routing entries. The
system does not allocate any IPv6 route entries by default for /64-bit prefix, and the user must
allocate some resources before using IPv6.
Each IPv6 /64-bit route requires twice the amount of resources taken up by an IPv4 route.
The number of hardware route entries allocated by the software for IPv6 /64-bit routes is
equal to twice the amount of the value specified using this command.
3HE 17358 AAAB TQZZA
Number of Resources Available for Maximum IP Subnets
Platforms
7210 SAS-S 1/10GE
(standalone and standalone-VC)
7210 SAS-Sx 10/100GE
Use subject to Terms available at: www.nokia.com
Min Value Max Value (per
(per node) node)
1 12288
1 12288
© 2021 Nokia.
System Management
Default Values
2000
2000
567