Procedure To Connect To A Console; Location Of Console Ports On 7210 Sas Platforms - Nokia 7210 Configuration Manual

Boot Options
4.10.3.5
Perform this procedure to establish a console connection to any platform.
4.10.3.6
This section provides console port information, supported variants, and modes of
operation for the following 7210 SAS platforms:
4.10.3.6.1
The 7210 SAS-M is a multilayer service-aware MPLS-capable switch. It supports two
modes of operation:
The switch is available as two variants, as follows:
166

Procedure to Connect to a Console

1. Connect the terminal to the Console port on the front panel using the serial
cable. See

Location of Console Ports on 7210 SAS Platforms

about the console port and its placement on the 7210 SAS platforms.
2. Power on the terminal.
3. Establish the connection by pressing the <Enter> key a few times on your
terminal keyboard.
4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
Location of Console Ports on 7210 SAS Platforms
• 7210 SAS-M Console Port
• 7210 SAS-T Console Port
• 7210 SAS-R6 Console Port
• 7210 SAS-R12 Console Port
• 7210 SAS-Mxp Console Port
• 7210 SAS-Sx 1/10GE Console Port
• 7210 SAS-S 1/10GE Console Port
• 7210 SAS-Sx 10/100GE Console Port
7210 SAS-M Console Port
• access-uplink mode (only L2 uplinks)
• network mode (L2 or MPLS uplinks)
• 7210 SAS-M 24F with support for up to 24 100/1000 SFP ports (see
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
for information
Figure 11)
3HE 17358 AAAB TQZZA