Manual Mode - Nokia 7210 Configuration Manual

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
4.1.2.1.1
After successful bootup using the
ping check to ensure that the system has IP connectivity. The software loads the
configuration file and attempts to ping the destination node three times using the IP
address specified in the ping-address BOF parameter. If the ping check does not
succeed, the system is rebooted with the BOF reset after 1 minute and the boot
process is repeated. If the address in the BOF is zero or the ping address is not
specified, the ping check is not performed.
4.1.2.2
Manual mode has two options.
If the user opts for the manual mode boot procedure using the network to retrieve the
images and configuration for the first-time boot, the required parameters must be
specified for a successful system boot. Manual mode configurations require
authentication. The default password is password. BOF parameters that should be
configured include the following:
Note: The following caveats apply for manual mode on 7210 SAS platforms.
3HE 17358 AAAB TQZZA
Ping Check in Auto-init Mode

Manual Mode

• Either use the starter BOF or configure the BOF to point to a local image to use
the image files on the flash that are shipped with the node.
• Configure the BOF to retrieve the image files from the network.
• image path
• configuration file path
• uplinkA parameters (port number, VLAN ID, IP/mask, static route)
• uplinkB parameters (port number, VLAN ID, IP/mask, static route)
• eth-mgmt-disable
• UplinkA and uplinkB parameters are only supported on the 7210 SAS-M, 7210 SAS-T,
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE operating in standalone mode, and
7210 SAS-Sx 10/100GE.
• On 7210 SAS-R6 and 7210 SAS-R12, the out-of-band (OOB) Ethernet management
port can be used to retrieve the image and configuration file from the network.
• The auto-init mode is not supported on 7210 7210 SAS-Sx/S 1/10GE (standalone-VC),
7210 SAS-R6, and 7210 SAS-R12.
Use subject to Terms available at: www.nokia.com
Auto-init Mode
© 2021 Nokia.
procedure, the software initiates a
Boot Options
121

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents