Rebooting - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Example:
4.11.1.5
When an admin>reboot command is issued, the system reboots. Changes are lost
unless the configuration is saved. Use the admin>save file-url command to save
the current configuration. If no command line options are specified with the reboot
command, the user is prompted to confirm the reboot operation. However, if the now
option is specified, the user is not prompted to confirm the reboot operation.The
reboot upgrade command forces an upgrade of the device firmware (CPLD and
ROM) and reboots the system.
Note: The auto-init option is supported on the 7210 SAS-M, 7210 SAS-T, 7210 SAS-Mxp,
7210 SAS-Sx/S 1/10GE (standalone), and 7210 SAS-Sx 10/100GE (standalone). It is not
supported on 7210 SAS-R6, 7210 SAS-R12, and platforms configured in standalone-VC
mode.
Use the following CLI syntax to reboot.
CLI Syntax:
A:DutA>admin# reboot
Are you sure you want to reboot (y/n)? y
Resetting...OK
Nokia 7210 Boot ROM. Copyright 2016 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Running POST tests from ROM
Testing ROM load area...done
Relocating code...Jumping to RAM
...
When an admin reboot auto-init command is issued, the system resets the existing
BOF and reboots. The system startup process after the admin reboot auto-init
command is executed is the same as the first time system boot as described in
System
3HE 17358 AAAB TQZZA
A:ALA-1>admin# save cf1:\testABC.cfg
Saving config.# Saved to cf1:\testABC.cfg
... complete
A:ALA-1#

Rebooting

admin# reboot [upgrade] [auto-init] [now]
Initialization.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
Boot Options
183