Basic Cli Commands - Nokia 7210 Configuration Manual

CLI Usage
A:ALU-7210# config
A:ALU-7210>config#
In a CLI context, you can enter commands at that context level by entering the text.
It is also possible to include a command in a lower context as long as the command
is formatted in the correct command and parameter syntax.
The following example shows two methods to navigate to a service SAP ingress
level:
Method 1:
A:ALU-7210# config service epipe 6 sap 1/1/2 ingress
Method 2:
A:ALU-7210# configure
A:ALU-7210>config# service
A:ALU-7210>config>service# epipe 6
A:ALU-7210>config>service>epipe# sap 1/1/2
A:ALU-7210>config>service>epipe>sap# ingress
A:ALU-7210>config>service>epipe>sap>ingress#
The CLI returns an error message when the syntax is incorrect.
A:ALU-7210>config>service>epipe# sapp
Error: Bad command.
A:ALU-7210>config>service>epipe#

2.2.2 Basic CLI Commands

The console control commands are the commands that are used for navigating within
the CLI and displaying information about the console session. Most of these
commands are implemented as global commands. They can be entered at any level
in the CLI hierarchy with the exception of the password command, which must be
entered at the ROOT level. The console control commands are described in
Table 5
26
Console Control Commands
Command Description
Aborts the pending command.
<Ctrl-c>
Terminates the pending command line and returns to the ROOT
<Ctrl-z>
context.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
^
© 2021 Nokia.
Configuration Guide
Table 5.
3HE 17358 AAAB TQZZA