Virtual Chassis Command Reference; Command Hierarchies; Configuration Commands; Command Descriptions - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide

5.9 Virtual Chassis Command Reference

5.9.1 Command Hierarchies

5.9.1.1
Note: See
bof

5.9.2 Command Descriptions

5.9.2.1
5.9.2.1.1
vc-stack-node
Syntax vc-stack-node {cpmA | cpmB} slot-num slot-num mac-addr mac-address
no vc-stack-node {cpmA | cpmB}
Context bof
Platforms 7210 SAS-S 1/10GE and 7210 SAS-Sx 1/10GE: standalone-vc mode
Description This command configures the nodes that will be CPM-IMM nodes in a virtual chassis (VC).
The slot number can be set to any number from 1 to 8 as long as it is not in use by another
VC member node. The slot number identifies a specific node or card in the VC similar to the
slot ID of a card in a chassis-based system, and is used in addressing service objects created
during provisioning.
3HE 17358 AAAB TQZZA

Configuration Commands

BOF Command Reference
— vc-stack-node {cpmA | cpmB} slot-num slot-num mac-addr mac-address
— no vc-stack-node {cpmA | cpmB}
Configuration Commands
Standalone Virtual Chassis (VC) Commands
Use subject to Terms available at: www.nokia.com
for more information about BOF commands.
© 2021 Nokia.
Virtual Chassis
247