Auto Tuning Mode Operation - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

7. GENERAL GAIN ADJUSTMENT

7.2.2 Auto tuning mode operation

The block diagram of real-time auto tuning is shown below.
www.DataSheet4U.com
Parameter No. 2
Gain adjustment
mode selection
When a servo motor is accelerated/decelerated, the load inertia moment ratio estimation section always
estimates the load inertia moment ratio from the current and speed of the servo motor. The results of
estimation are written to parameter No.34 (the ratio of load inertia moment to servo motor). These results can
be confirmed on the status display screen of the MR Configurator (servo configuration software) section.
If the value of the load inertia moment ratio is already known or if estimation cannot be made properly, chose
the "auto tuning mode 2" (parameter No.2:
(Switch in above diagram turned off), and set the load inertia moment ratio (parameter No.34) manually.
From the preset load inertia moment ratio (parameter No.34) value and response level (The first digit of
parameter No.2), the optimum control gains are automatically set on the basis of the internal gain tale.
The auto tuning results are saved in the EEP-ROM of the servo amplifier every 60 minutes since power-on. At
power-on, auto tuning is performed with the value of each control gain saved in the EEP-ROM being used as
an initial value.
Control gains
Command
PG1,VG1
PG2,VG2,VIC
Set 0 or 1 to turn on.
Gain
table
First digit
Response level
setting
POINT
If sudden disturbance torque is imposed during operation, the estimation of the
inertia moment ratio may malfunction temporarily. In such a case, choose the
"auto tuning mode 2" (parameter No.2:
moment ratio in parameter No.34.
When any of the auto tuning mode 1, auto tuning mode 2 and manual mode 1
settings is changed to the manual mode 2 setting, the current control gains and
load inertia moment ratio estimation value are saved in the EEP-ROM.
Automatic setting
Current feedback
Real-time auto
tuning section
Load inertia
moment ratio
Switch
estimation section
Parameter No. 34
Load inertia moment
ratio estimation value
2 ) to stop the estimation of the load inertia moment ratio
7 - 4
Load inertia
moment
Encoder
Current
Servo
control
motor
Position/speed
feedback
Speed feedback
2 ) and set the correct load inertia