Model Code Definition; Parts Identification - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

15. MR-E- AG-QW003 SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT

15.1.4 Model code definition

MR-E - AG QW003
Series name
Rated output
Symbol Rated output [W]
10
20
40
www.DataSheet4U.com

15.1.5 Parts identification

(1) MR-E-100AG-QW003 or less
MODE
MITSUBISHI
MR-
CN2
CNP2
CNP1
Fixed part
(MR-E-10AG-QW003 to MR-E-40AG-QW003: 2 places
MR-E-70AG-QW003 MR-E-100AG-QW003: 3 places)
-
MR-E super servo amplifier
(Source I/O interface)
Analog input interface
Symbol Rated output [W]
100 70 750
200 100 1000
400 200 2000
SET
CN3
CN1
MR-E-40AG-QW003 MR-E-70AG-QW003,
or less MR-E-100AG-QW003
Rating plate Rating plate
Name/application
Display
The 5-digit, seven-segment LED shows the servo status
and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
UP DOWN
MODE SET
Communication connector (CN3)
Used to connect a command device (RS-232C) and
output analog monitor data.
I/O signal connector (CN1)
Used to connect digital I/O signals.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Servo motor power connector (CNP2)
Used to connect the servo motor.
Power supply/regenerative connector (CNP1)
Used to connect the input power supply and regenerative
option.
Protective earth (PE) terminal (
Ground terminal.
15 - 4
MR-E-200AG-QW003
Rating plate
Reference
Chapter 6
Used to set data.
Chapter 6
Used to change the
display or data in each
mode.
Used to change the
mode.
Section 3.3
Section 13.1.2
Chapter 14
Section 3.3
Section 3.3
Section1 3.1.2
Section 3.7
Section 11.1
Section 3.7
Section 11.1
Section 13.1.1
)
Section 3.10
Section 11.1