Parts Identification - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.7 Parts identification

(1) MR-E-100A-QW003 or less
www.DataSheet4U.com
MODE
CN3
MITSUBISHI
MR-
CN2
CNP2
CNP1
Fixed part
(MR-E-10A-QW003 to MR-E-40A-QW003: 2 places
MR-E-70A-QW003 MR-E-100A-QW003: 3 places)
SET
CN1
Name/application
Display
The 5-digit, seven-segment LED shows the servo status
and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
UP DOWN
MODE SET
Communication connector (CN3)
Used to connect a command device (RS-232C) and
output analog monitor data.
I/O signal connector (CN1)
Used to connect digital I/O signals.
Encoder connector (CN2)
Use to connect the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Servo motor power connector (CNP2)
Used to connect the servo motor.
Power supply/regenerative connector (CNP1)
Used to connect the input power supply and regenerative
option.
Protective earth (PE) terminal (
Ground terminal.
1 - 7
Reference
Chapter 6
Used to set data.
Chapter 6
Used to change the
display or data in each
mode.
Used to change the
mode.
Section 3.3
Section 13.1.2
Section 3.3
Section 3.3
Section1 3.1.2
Section 3.7
Section 11.1
Section 3.7
Section 11.1
Section 13.1.1
)
Section 3.10
Section 11.1