Figure 14 Service Controller; Table 11 Name And Function Of The Panel Key - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Frontend Enclosures (ETERNUS DX900 S5)
●
Panel Keys
The name and function of each panel key are described in
Table 11 Name and Function of the Panel Key
Panel key name
FUNCTION
INPUT
DISPLAY
CURSOR
SETTING
CLEAR
For details on the menu operations using the panel keys, refer to
(page 91).
●
Power Switch
This switch is used to turn on or off the ETERNUS DX.
• The ETERNUS DX that is currently off is turned on by pressing the Power switch.
The ETERNUS DX that is currently on is turned off by pressing the Power switch for four seconds or more.
•
Power switch operations are disabled during the remote mode (or when the REMOTE LED is turned on).
•
• Power switch operations are available when both the remote mode (or when the REMOTE LED is turned
on) and the maintenance state (or when the MAINTENANCE LED is turned on) are enabled.
■
Service Controllers (SVC)
An SVC coordinates with the controller and is a unit that controls the monitoring function for the entire ETERNUS
DX.
Two units are installed in a frontend enclosure.
Figure 14 Service Controller
2
1
CM ports
This port is used to connect SVCs and CMs.
2
PWC port
The PWC port is used to connect a power synchronized unit to perform power synchronization.
Function
Starts the menu operation or selects the menu.
Confirms or executes the menu operation.
Displays multiple messages on the LCD panel.
Moves the cursor in the LCD panel.
Inputs data into the LCD panel.
Cancels or terminates the menu operation.
1
89
Table 11.
"Menu Operation Using the Panel Key"
Operation Guide (Basic)