Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 22

1. Basic Operation
Powering On and Off
• After power-off, wait for about one minute before turning power on again.
This section explains how to use the Power switch and the power synchronization unit to turn off the ETERNUS
DX.
For other procedures, refer to the related manuals.
■
When Controlling by the Power Switch
1
Press the Power switch of the controller enclosure or the frontend enclosure for four seconds or more.
Controller enclosure
Frontend enclosure
The READY LED on the controller enclosure or the frontend enclosure is turned off.
IMPORTANT
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.
2
The power of the ETERNUS DX is disconnected.
When the power is disconnected, the POWER LED of each enclosure is turned off.
■
When a Power Synchronized Unit Is Used
If the server is turned off, the ETERNUS DX is also turned off.
Power switch
ETERNUS DX60 S5/DX100 S5/DX200 S5
Power switch
ETERNUS DX900 S5
Power switch
ETERNUS DX500 S5/DX600 S5
22 Operation Guide (Basic)