Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 42

4. Component Expansion/Function Enhancement
Installing Additional Drives
(3)
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
(4)
Check the status of the LED on the Disk Activity Panel (DAP) of the added drive.
11
To install more additional drives, repeat
12
Close the top board.
13
Insert the high-density drive enclosure all the way into the rack while pulling the stopper catches on both
sides of the high-density drive enclosure back.
14
Push the stopper catches to lock the high-density drive enclosure.
15
Fasten the high-density drive enclosure to the rack pillar with the M5 screws that were removed in
16
Attach the front cover.
17
If a wrist strap is used, remove the wrist strap.
18
In the [Drives] screen of [Component] on the ETERNUS Web GUI screen, check that the added drives have
been recognized.
19
Set up RAID groups, volumes, hot spares, and host affinity settings, as required.
Step 9 and Step 10.
42
Step 4.
Operation Guide (Basic)